aluminum outdoor web lawn folding chairs

It was 1956 when Arnold first patented his aluminum folding seat-aka the lawn chair-and it didn't take long for its appeal to grow. But there's something about those throwback metal and webbed lawn chairs that make them a close second in terms of coziness: nostalgia.įredric Arnold might not be a name that rings a bell for most Southerners, yet you would be hard-pressed to find someone who doesn't recognize the inventor's most memorable creation. We'll always love a good patio sofa and the buttery soft outdoor cushions that sit atop it. Replace any other missing strips in the same way.If there's one thing you'll never hear us complain about, it's the strides outdoor furniture has made toward becoming as indoors-like as possible. Fold the excess webbing up and under the frame. Be sure the clip points toward the frame and curves up.

Stick another clip through the webbing at the mark. Mark the location of the hole with a permanent marker. Be sure these strips go under the bar at the bottom (back) of the seat. Weave vertical strips with the chair folded. If the strips on either side go under, weave it over if they go over, weave it under. Wrap the strip up around the frame and over to the other side, weave it over and under every other strip. Insert the clip in the hole in the frame. Push one of the clips from the webbing kit through one end of the webbing, 2 inches from the end. Add 4 inches to this measurement to calculate the length of the vertical straps.Ĭut your strips to these measurements. Measure the distance from the center hole on the front of the top of the seat, down around the metal bar at the back of the seat, and up to the center hole on the top of the front of the seat. Measure the distance between the holes for the vertical straps with the chair folded. Add 4 inches to this measurement to calculate the length of the horizontal straps.

For the straps that run from one side of the chair to the other, measure the distance between corresponding holes on either side of the top of the seat. Measure the distance between the holes in the frame of the chair. Replace any other missing strips in the same way. Stick another screw through the strip so it aligns with the hole in the frame. Wrap the end of the strip around the other side of the frame. Be sure to go under the bar at the bottom (back) of the seat.įold the other end of the strip into another point with the folds facing down. If the strips on either side go under weave it over, if they go over weave it under. Wrap the strip of webbing around the frame and weave it over and under every other strip. Screw it into the hole on the bottom or back of the frame where a strip is missing, so the strip sticks out from the frame. Stick a screw through the center of this point. The end of the strip will be a 90-degree point. Fold this side down so it is perpendicular to the side of the webbing. Fold the end of the strip at a 45-degree angle so the top of the strip is touching the side of the strip.

Aluminum outdoor web lawn folding chairs